Calculates urine albumin-to-creatinine ratio in mg/mmol.
Urine Albumin–Creatinine Ratio: Clinical Guide
Browse Knowledge HubCalculates urine albumin-to-creatinine ratio in mg/mmol. This guide explains the method, appropriate use, interpretation and limitations.
Overview
Calculates urine albumin-to-creatinine ratio in mg/mmol.
Clinical Significance
ACR is preferred for detecting and staging albuminuria. Confirm persistent elevation with repeat testing according to guideline recommendations.
When to Use
- Use when the stated clinical calculation is relevant to the patient and decision being considered.
- Use contemporaneous measurements obtained with appropriate technique.
- Confirm that the equation and units match local practice before acting on the result.
How It Is Calculated
- ACR (mg/mmol) = urine albumin (mg/L) ÷ urine creatinine (mmol/L).
Interpretation
- ACR is preferred for detecting and staging albuminuria. Confirm persistent elevation with repeat testing according to guideline recommendations.
- Interpret trends and the full clinical picture rather than relying on a single calculated value.
Worked Example
Enter a valid set of the required measurements. MedicalC applies: ACR (mg/mmol) = urine albumin (mg/L) ÷ urine creatinine (mmol/L). The displayed result should then be checked against the clinical context and local guidance.
Patient Considerations
- Consider whether physiology, treatment or sampling conditions changed between measurements.
- Consider whether the patient differs from the population in which the equation is normally used.
Limitations
- The result is only as reliable as the entered measurements and assumptions behind the equation.
- The calculator does not replace clinical assessment, definitive measurement or specialist advice.
- Thresholds and interpretation may vary between populations, laboratories and clinical pathways.
Clinical Pearls
- Confirm units before calculation.
- Use values obtained at the same clinical time point.
- Document the component measurements with the calculated result.
Common Mistakes
- Mixing SI and conventional units.
- Using estimated or non-contemporaneous measurements without acknowledging uncertainty.
- Treating a calculated value as a diagnosis or treatment instruction.
Evidence Base
The implemented equation follows the established published or guideline-based relationship: ACR (mg/mmol) = urine albumin (mg/L) ÷ urine creatinine (mmol/L).
Frequently Asked Questions
What does the Urine Albumin–Creatinine Ratio calculator do?
Calculates urine albumin-to-creatinine ratio in mg/mmol.
Can the result be used alone?
No. It should support, not replace, clinical assessment and current guidance.
Why might the result be unreliable?
Incorrect units, poor measurement quality, non-contemporaneous inputs or use outside the intended setting can produce misleading results.
Should the calculation be repeated?
Repeat it when relevant measurements or the patient’s clinical condition change.
References
- KDIGO Clinical Practice Guideline for the Evaluation and Management of CKD. — Primary publication, guideline or established physiologic source supporting the equation.
Reviewed by: MedicalC Clinical Editorial Team
Last reviewed: July 2026
Clinical Disclaimer
MedicalC calculators and clinical tools are intended to support healthcare professionals. They do not replace clinical judgement, individual patient assessment, local guidance or specialist advice.
Results should always be interpreted in the context of the patient’s history, examination, investigations, current clinical condition and applicable professional guidance.