Urine Protein–Creatinine Ratio: Clinical Guide

Overview

Calculates a spot urine protein-to-creatinine ratio in mg/g.

Clinical Significance

A spot PCR estimates daily protein excretion but varies with muscle mass, urine concentration and timing. Apply local laboratory thresholds.

When to Use

• Use when the stated clinical calculation is relevant to the patient and decision being considered.
• Use contemporaneous measurements obtained with appropriate technique.
• Confirm that the equation and units match local practice before acting on the result.

How It Is Calculated

• PCR (mg/g) = urine protein (mg/dL) ÷ urine creatinine (mg/dL) × 1000.

Interpretation

• A spot PCR estimates daily protein excretion but varies with muscle mass, urine concentration and timing. Apply local laboratory thresholds.
• Interpret trends and the full clinical picture rather than relying on a single calculated value.

Worked Example

Enter a valid set of the required measurements. MedicalC applies: PCR (mg/g) = urine protein (mg/dL) ÷ urine creatinine (mg/dL) × 1000. The displayed result should then be checked against the clinical context and local guidance.

Patient Considerations

• Consider whether physiology, treatment or sampling conditions changed between measurements.
• Consider whether the patient differs from the population in which the equation is normally used.

Limitations

• The result is only as reliable as the entered measurements and assumptions behind the equation.
• The calculator does not replace clinical assessment, definitive measurement or specialist advice.
• Thresholds and interpretation may vary between populations, laboratories and clinical pathways.

Clinical Pearls

• Confirm units before calculation.
• Use values obtained at the same clinical time point.
• Document the component measurements with the calculated result.

Common Mistakes

• Mixing SI and conventional units.
• Using estimated or non-contemporaneous measurements without acknowledging uncertainty.
• Treating a calculated value as a diagnosis or treatment instruction.

Evidence Base

The implemented equation follows the established published or guideline-based relationship: PCR (mg/g) = urine protein (mg/dL) ÷ urine creatinine (mg/dL) × 1000.

References

1. KDIGO Clinical Practice Guideline for the Evaluation and Management of CKD. — Primary publication, guideline or established physiologic source supporting the equation.