Vancomycin Projected Trough Concentration Calculator

Overview

Projects a measured vancomycin concentration to the end of the dosing interval.

Clinical Significance

The calculation estimates the concentration immediately before the next dose but should not substitute for AUC-guided assessment where indicated.

When to Use

• Use when the required concentration, timing and dosing information are reliable and the stated pharmacokinetic assumptions are reasonable.
• Use within an approved therapeutic-drug-monitoring or medicines-governance pathway.
• Use to support transparent review, not to automate prescribing.

How It Is Calculated

• C(trough) = C(measured) × e^[−k × (interval − sample time)].
• MedicalC validates that all required inputs are numeric and rejects internally impossible time or concentration relationships where applicable.

Interpretation

• The calculation estimates the concentration immediately before the next dose but should not substitute for AUC-guided assessment where indicated.
• Interpret the result with the clinical indication, microbiology or seizure control, organ function, assay timing and local targets.

Worked Example

Enter a verified set of source values in the displayed units. MedicalC applies: C(trough) = C(measured) × e^[−k × (interval − sample time)]. Recheck the source chart and sampling times before using the result.

Patient Considerations

• Primarily intended for adults receiving intermittent intravenous vancomycin. Paediatrics, pregnancy, obesity, augmented renal clearance, dialysis, extracorporeal support, burns and unstable renal function require specialist methods.
• Consider acute kidney injury, augmented renal clearance, fluid shifts, obesity, burns, pregnancy, critical illness and interacting medicines.

Limitations

• One-compartment equations may not describe distribution or multicompartment behaviour accurately.
• Derived values can appear precise despite uncertainty in sampling time, assay result and clearance stability.
• A calculated exposure or dose does not establish clinical benefit or safety.

Clinical Pearls

• Trough concentration and AUC are related but not interchangeable; identical troughs can correspond to materially different AUC exposures.
• Plot concentrations against actual elapsed time before accepting any pharmacokinetic slope.
• When the result conflicts with the patient, verify the data rather than forcing a dose change.

Common Mistakes

• Using scheduled rather than actual administration and blood-sampling times.
• Treating a level drawn during distribution as a post-distribution concentration.
• Mixing mg/L, micrograms/mL and micrograms/L.
• Applying steady-state equations before steady state or during changing clearance.
• Using a generic concentration target outside the relevant indication or local protocol.

Evidence Base

Principal source: Rybak MJ, et al. Therapeutic monitoring of vancomycin for serious MRSA infections: revised consensus guideline. Am J Health Syst Pharm. 2020.

References

1. Rybak MJ, et al. Therapeutic monitoring of vancomycin for serious MRSA infections: revised consensus guideline. Am J Health Syst Pharm. 2020. — Primary publication, consensus guideline or authoritative pharmacokinetic source.